Get A Quote

Can I use MW LED drivers at full load continuously? Most of the AC/DC power supply are suggested to use at 70% load.

Posted by

admin

–

LED Drivers are recommended operate at full load as long as it observes the working temperature specified in the datasheet, which means Tc measurement results should be equal to or less than the stated Tc in the datasheet. 5 years warranty complies as long as drivers operate within working Temp and Tc. Limit as well.

Recent Posts

Tag Cloud

-V 2-in-1 3 in 1 dimming 3-phase 3-wire 3-phase 4-wire 3+N 3+N system solution 3+N system solutions AC and DC accuracy adjustment batteries Battery Charger CAN bus can not turn on the power supply CASAMBI CE charging curve check choose power supply CMU2 COM connected in parallel connecting constant power contact Contact Us control cooling fans DALI DALI-1 DALI2 dimming discontinued DMTBF EMC ENEC fail signals full load continuously GND high altitude industrial adaptor Ingress Protection Inrush Current intelligent products inverte IOT IOT wireless IOT wireless lighting control solutions? IP67 IP68 is defected knx LDD LDH LED CC LED flickers LED power LPS LVLE magnetic component MCB minimum load minimum load requirement MOOP MOP MOPP MTBF Noise noise of fan Notes on choosing overcurrent overload pbc pfc power supply startup failure product discontinued product information questions recycling Remote Sensing report Ripple RMA RoHs S.P.S safety standards Scope Use select adaptors serial connection Single Stage solution solutions specification support surge test switching time TN-1500 Two Stage Type HL voltage is found on the outer case warranty years WEEE wireless lighting control Withstand Voltage

Leave a Message