Get A Quote

How to increase communication reliability for CAN bus?

Posted by

admin

–

As differential signaling, adding termination resistors at the both far end of the bus can minimize signal reflection and then increase communication reliability for the interface. A suitable resistor is 120 ohms +/- 10 ohms with mini power rated of 220mw.

Recent Posts

Tag Cloud

-V 2-in-1 3 in 1 dimming 3-phase 3-wire 3-phase 4-wire 3+N 3+N system solution 3+N system solutions AC and DC accuracy adjustment batteries Battery Charger CAN bus can not turn on the power supply CASAMBI CE charging curve check choose power supply CMU2 COM connected in parallel connecting constant power contact Contact Us control cooling fans DALI DALI-1 DALI2 dimming discontinued DMTBF EMC ENEC fail signals full load continuously GND high altitude industrial adaptor Ingress Protection Inrush Current intelligent products inverte IOT IOT wireless IOT wireless lighting control solutions? IP67 IP68 is defected knx LDD LDH LED CC LED flickers LED power LPS LVLE magnetic component MCB minimum load minimum load requirement MOOP MOP MOPP MTBF Noise noise of fan Notes on choosing overcurrent overload pbc pfc power supply startup failure product discontinued product information questions recycling Remote Sensing report Ripple RMA RoHs S.P.S safety standards Scope Use select adaptors serial connection Single Stage solution solutions specification support surge test switching time TN-1500 Two Stage Type HL voltage is found on the outer case warranty years WEEE wireless lighting control Withstand Voltage

Leave a Message